5

Нужные страницы

Translate

Search

Monday, October 9, 2017

Quick add special symbols to Solidworks


When filling in those. requirements it is necessary to put a symbol of diameter, plus-minus, degree, etc. Adding using the symbol table is not fast. And in the design it is desirable to optimize the routine work, it means the design of the drawings.
For example, to insert a symbol from a symbol table, you need to go through three menus, and then select the one you need from a large number of fonts. Yes, there is a huge choice in the symbol table, but the designer does not need technical requirements for it, it needs quite a few special symbols.
Solidworks - Добавление спецсимволов
 Adding special symbols


Solidworks - Библиотека обозначений
The Symbol Library
Solidworks - Таблица символов
The Symbol Table


If you apply a dimension, the symbol of diameter and degree can be added quickly.
Solidworks - Добавление диаметра в размер
Adding a diameter

then in the notes so simply does not work. It will be necessary to make quite a large number of mouse clicks until you get to the required symbol. Fortunately, there is the ability to quickly enter special characters using ALT-codes. To enter a special character, press and hold ALT to enter the numeric character code.
List of most frequently used:


English keyboard!
(±); input: ALT+0177
(°); input: ALT+0176
(²); input: ALT+0178
(³); input: ALT+0179 
(Ø); input: ALT+0216
(ø); input: ALT+0248 



Of course, on this list of ALT-codes is not limited, the full list can be found in nete, on the same wikipedia.
I think that to speed up the input to remember a few digital codes will not be difficult, try. Of course, you can enter some special characters using internal Solidworks codes such as <MOD-DIAM>, <MOD-DEG>, <MOD-PM>. What is the analog of diameter, degree and plus or minus. But the ALT code is shorter and easier to type.

No comments:

Post a Comment